STEP 2 - Spritz your acetate with alcohol blending solution - It should appear something like this.

 

 

 

STEP 5 - Stamp your image again and colour it in with your promarkers. Then place a piece of card over the image as a mask to protect the rest of this as this bit is messy! Take a piece of mesh and colour some of it in with a contrasting colour to what you have done the tail in. Here I coloured the tail with greens and the mesh with plum. Spritz once and lightly then carefully place the mesh over the tail piece and press down.

Have a couple of practice runs first until you feel confident with it. I had practice runs on my hand (I've no idea why but it seemed like a good idea at the time!)

I've distressed the green DP with scissors and the oval with ink. Found these fab jewel roses when I sorted out my craft room so I snipped a bigger hole in the bead caps with my cropodile for them to slot through. I also found the butterfly punch so used that too :D

Close up of the ickle earrings I made with a 4mm daisy spacer and sticky pearl gem.

Close up of stick pin I made with a 10mm AB teardrop bead, 6mm green cats eye and silver star charm.

Tutorial by Vix